To fill a basement after a tear-down, get the debris out, break up the floor so water can drain, then fill the hole with clean fill packed in layers. Finish with topsoil graded so water runs away from the spot.
Have an old basement to fill? Trey clears the debris, breaks the floor so it drains, packs clean fill in layers and grades the top, from Campbellsville and Lebanon out across central Kentucky. More on our demolition page. Call (270) 272-8739 or send the form for a straight quote.
Why a basement hole is worth doing right
A filled basement looks done the day the machine leaves. The trouble shows up later. Fill that was pushed in loose settles a little every time it rains, and in a year or two there is a soft, sunken square where the house stood. If a new slab, a shop or a driveway goes over it, that sinking cracks it. On sinkhole and limestone ground, found in many parts of central Kentucky, a hole that holds water can also make a bad spot worse. Doing the fill in steps costs less than fixing a sunken yard.
Get the debris out first
The first step is emptying the basement. Wood, drywall, shingles, carpet, metal and trash come out and get loaded out. Rotting wood in a fill makes voids, and voids settle. Ask your county before anything from the house is buried on site, and do not assume it is allowed. Clean concrete and block from the walls are a different question; some owners and offices allow broken masonry in the bottom of the hole and some do not, so ask. Our basement clean-out page covers emptying a basement to the walls.
Break the floor so water can leave
A concrete basement floor left whole turns the hole into a bathtub. Rain soaks down through the fill, hits the slab and sits there, and the fill above stays soft. The usual fix is to break the floor up, or at least punch plenty of holes in it, so water can soak away. The walls are the other decision. Many owners have them knocked down below the finished grade so nothing pokes up later. Ask your local building office whether it sets a rule for how far down the walls must come.
What counts as clean fill
Good fill is dirt and rock that will pack hard and stay put: clay or clay-and-rock from a cut, with no stumps, roots, trash or building debris mixed in. Topsoil does not belong deep in the hole, since it is full of organic matter that rots and settles. Where the fill comes from moves the cost. Dirt from your own place, such as a high spot that needs cutting down, saves the trucking. Hauled-in fill adds trucking. Trey will talk through where the dirt can come from.
Packed in layers, not dumped
The fill goes in a layer at a time. Each lift is spread and run over with the machine to pack it before the next one goes on. Dumping it all in at once leaves the bottom loose under a hard crust, and that is what settles later. Clay should be worked when it is damp, not soupy and not powder dry. If a building will sit on the spot, tell Trey before the fill starts. Your builder may want the fill done a certain way or tested, and it is easier to plan for that up front.
Grade the top and plan the next step
The last lift is topsoil, graded so water runs off the old footprint and away from any building nearby. A slight crown is better than a dip. Seed and straw keep it from washing. If you plan to build again, the choices are to build off the old hole or to build over a fill that was done right. See site preparation for getting a lot ready, and our house demolition cost guide for what the fill adds to a tear-down. Keep heavy trucks off the new fill for a while if you can.
What to do next
If a house with a basement is coming down, plan the fill before the tear-down starts. Call (270) 272-8739 or send the form, and Trey will look at the basement, ask what goes on the spot next, and give you a straight quote.
Trey will look at the hole and the lot and give you a straight quote before any fill comes in.
See our demolition service, call (270) 272-8739 or contact us.

